Automatic technology garage door opener manual

Table Of Contents. Table of Contents.

This opener is designed to suit sectional overhead and one piece tilt up doors. The components and materials used in this opener are of the latest technology and highest quality. Listed below are some of the many features. Operation To open or close the door simply press the hand held transmitter, the wall mounted transmitter, or optional wall switch for two seconds. During an open or close cycle the door can be stopped by pressing the button while the door is in motion. The next actuation will move the door in the opposite direction.

Automatic technology garage door opener manual

Hide thumbs. Table Of Contents. Table of Contents. Quick Links. Previous Page. Next Page. Please save these instructions for future reference. Page 3: Table Of Contents Technology Australia Pty Ltd hereby further expressly excludes all or any liability for any injury, damage, cost, expense or claim whatsoever suffered by any person as a result whether directly or indirectly from failure to install the Automatic Technology Australia Pty Ltd Garage Door Opener in accordance with these installation instructions. Page 4: Safety Information 1. These safety alert symbols indicate personal safety property damage instruction exists.

Table of Contents. AUX output can be used to control alarm system. Up to 24 different transmitters can be stored in the openers memory.

SET button orange is used during the installation phase together with the Open and Close buttons to set the door limit positions. The Set button is also used to re-initialize the Opener. Pressing and holding this button will move the door in the open direction, releasing stops the door. It illuminates and fl ashes when the door is opening and remains steady on when the open limit position has been reached. The margin can be adjusted manually using the Force Margin Set button White. The Force Margin Set should only be used if environmental factors wind, etc.

Hide thumbs. Table Of Contents. Table of Contents. Quick Links. Overhead Garage Door Operator.

Automatic technology garage door opener manual

Hide thumbs. Table Of Contents. Table of Contents. Quick Links. GDOv1 SecuraLift. Overhead Garage Door Opener. Previous Page.

Travelodge in edmonton green

Follow ALL installation instructions. Open the door completely and tie safety ropes around the door roll approximately mm from each end. Next Page. The amount of force the door should encounter before reversing is automatically adjusted by the doors control system during the initial installation of the automatic door opener. Next Page. If the power to the opener is disrupted for any reason the door can be put into manual mode by pulling down on the string handle on an angle towards the door. Sign up! ISS intelligent safety obstruction system While the door is performing a close cycle, should it hit an obstacle or be restricted in some manner, it will automatically reverse. You may also wish to open the door to a height suitable only for pedestrian access. Operation To open or close the door simply press the hand held transmitter, the wall mounted transmitter, or optional wall switch for two seconds. Anti travel electronic brakes opener has anti travel electronic brake mechanism which ensure the opener stops the door at exact location. The components and materials used in this opener are of the latest technology and highest quality. Table Of Contents. The only lubricant suitable for use on door guides is silicon spray.

Table Of Contents.

Anti travel electronic brakes opener has anti travel electronic brake mechanism which ensure the opener stops the door at exact location. Delete bookmark? This greatly enhances the security of the system. Table of Contents. Phone Number. The light will stay on for approximately three minutes then switch off. Quick Links. All safety rules must be followed. Hide thumbs. Operation To open or close the door simply press the hand held transmitter, the wall mounted transmitter, or optional wall switch for two seconds. Search for:. This is done by pressing the button on any hand held or wall mounted transmitter which has been stored with the light code. Up to 24 different transmitters can be stored in the openers memory.